Church Quiet Book; the final product!


There are a few tiny changes I made since the version I showed you yesterday.
I’ve detached the leaves that were on the front cover as the material was a bad choice, they had started to fray because they get a lot of handling. I changed them for felt versions which won’t fray. I also made them slightly bigger and they cover the dragonfly button better, it did have a tendency to peak out! I also used my markers to colour the viliene sign into a better approximation of the real thing. I like it with a blue background much better!
Now a quick run through of the finished book!
Cover – “lift the flap” leaves and an opening door with a tiny vicar behind it. Original title page post here.
finger puppets page

The next two pages form a double page spread, the “dress the vicar” pages. Details here.

The next two pages feature a ringing bell (not so quiet!) and praying hands. Both pages here.


The next page features the inside of the church and a host of adorable finger puppets. For a closer look at these characters look here.


The baptism page has a jointed arm and can be found here, as can the button flower page. In the next spread. Eagle eyed readers may have noticed one of the buttons was missing but this has been fixed!


The communion page has broken bread which poppers on and off, this jigsaw is surprisingly difficult! Full details can be found here as can the information on the last spread, a colouring page based on the Sunday school.


The back cover is repurposed denim, this lends a bit of structure to the colouring page which is the heaviest page due to the notebook.

And that’s it! Stay tuned for the little dedication I’ll be adding but the book is out in the church and has been since Easter, where it went down well with some of the smaller members of the service who it entertained throughout. Success!


Church Quiet Book Construction.

Okay so this has been much delayed but this post is all about how to put together the final church quiet book. Originally I had planned to use book rings but eventually I decided that the less bits that could be lost the better, and since the book would be in a public place I chose to sew the pages together.


To start with I laid all the pages out in order. When deciding the order I tried to make sure bulky pages didn’t end up back to back.


Take any loose parts you can detach and put them to one side so they don’t get in the way. Here you can see my poor finger puppets scattered across the carpet.


Taking the two pages which will end up back to back, place them right sides together.


Pin around the edges, you are going the sew round all four sides leaving a gap for turning, as you would for a bean bag.


Sew around the page turning at the corners, and finish with a backstitch for strength.


Clip the corners to reduce the bulk when turning


Then turn the page right sides out through the turning gap.


Use something like a pencil or a knitting needle to push the corners though so your page is nice and square. This should leave you with a finished page.


Ready to put back and small pieces.


Now do the same for all the other pages except the back page.


The back page is constructed exactly the same way but using a piece of soft denim from a pair of worn out jeans. I cut some scrap from the jeans fabric which was approximately 2 inches. The decorative seam of the jeans was on this scrap.


I sewed a line of stitching alongside this seam on the front page of the book. This formed a wraparound spine for the book with the seam along the front.

The seam could be seen once the fabric is folded back to show the right side of the fabric.


To join the back and front cover I pinned the spine piece to the back cover. I then stitched down this join on the reverse of the fabric.


The inner pages were sewn together using a large zig zag stitch. The interior pages were stitched together in this way in twos.


The bundles were then sewn together by running a straight stitch down two pages close to the spine.

This gives you an (almost) finished book!

Round up of the finished article and tiny tweaks tomorrow!